Ford Error Code P0303 – Cylinder 3 Misfire Detected

Expert Insight: What Does Ford Error Code P0303 Mean?

P0303 refers to cylinder 3 misfire detected. This error code is commonly triggered when the ECM (Engine Control Module) receives out-of-range readings or fails to verify optimal engine operation logic during real-world load conditions.

Technical Causes Behind P0303

• Faulty sensor readings or intermittent signal dropout
• Fuel trim deviations due to injector wear or air leak
• Improper combustion feedback leading to system logic faults
• Wiring damage or high resistance in control circuits

️ Diagnostic Steps for P0303

1. Scan with enhanced OBD-II tool supporting Mode $06
2. Check freeze frame for engine temp, RPM, load at DTC occurrence
3. Perform visual and signal integrity tests on related sensors and wiring
4. Simulate load conditions during drive cycle to recreate fault

Proven Fix Strategy

1. Replace or clean sensors responsible (MAF, MAP, O2)
2. Test continuity and signal pattern using lab scope or DVOM
3. Clear codes, reset adaptive trims, and road test

Estimated Repair Costs

• Sensor Replacement: ₱1,500 – ₱6,000
• Diagnostics and Testing: ₱1,000 – ₱2,000
• Wiring or Connector Repair: ₱500 – ₱1,200

❓ FAQ – Ford P0303

Can P0303 trigger limp mode?

Yes. If multiple systems detect logic failure, limp mode may be engaged to prevent drivetrain damage.

Is this error code linked to fuel economy?

Absolutely. Most DTCs like P0303 affect efficiency due to poor combustion control.

Should I continue driving with P0303 active?

Short distances may be fine but immediate diagnosis is highly recommended to avoid compounding faults.